Skip to content

eVent Fabrics — Testing & Specifications

A waterproof breathable laminate needs more than one result. Read the liquid-water, vapor and airflow questions separately, then match the conditioning and post-treatment state before comparing specimens.

Testing and specifications

Testing and specifications — compare at least four dimensions
DimensionReview questionEvidence or next step
Water resistanceLiquid-water behaviourMethod, pressure and specimen state
Moisture transmissionVapour movementMethod and conditioning
Air permeabilityAirflow under a pressure differenceAirflow method, area and pressure difference
DimensionsChange under a stated treatmentSpecimen and conditioning

Put the method beside the result

Put the method name and edition beside every result. For hydrostatic head, identify the pressure procedure, exposed face and reporting endpoint. This is a liquid-water penetration question, not a vapor movement measurement. Describe the specimen as membrane-only or a laminate with its face and backing. Record conditioning, any pretreatment and the test date. A comparison between an untreated membrane and a washed laminate changes more than one variable and cannot isolate a construction difference. Read the report as a record of the stated specimen under the stated procedure, then decide whether that procedure addresses the intended outdoor use. Hydrostatic editions such as ISO 811 may report cm of water or kPa. A hot-plate method such as ISO 11092 reports water-vapour resistance as RET in m²·Pa/W. Those units describe different mechanisms and are not convertible.

Distinguish target and evidence

Write a buyer target in a separate field from an observed result. For physical specification, identify fiber composition, mass per unit area in g/m² and usable width in cm. State the relevant tolerances as requirements to agree. For water vapor transmission, keep the method, temperature, humidity conditions and reported units together. Different arrangements can create different transport conditions, so a larger figure from another method is not a direct ranking. Where results are available, compare specimens conditioned and treated through the same route. Preserve the dated sample reference and the full construction description alongside the report.

Treat performance dimensions separately

Treat air permeability as its own measurement: the report needs the airflow method, test area and pressure difference. It does not substitute for water vapor transmission, which concerns vapor transport, or hydrostatic head, which concerns liquid-water resistance. Add abrasion resistance and dimensional stability when the application needs them, stating the stopping condition and treatment sequence. A softer face textile and a more abrasion-focused one may create different handle priorities. A coating route raises coating add-on and adhesion questions; a membrane laminate adds backing and bonding-interface questions. Compare these routes through matched specimens and relevant criteria, rather than assuming that one construction category is universally preferable.

Keep treatment sequence and source scope together

Read a label or report within its stated material boundary. Identify the holder, product designation, date and covered process. A statement about a fiber or finish cannot be extended to every layer without supporting evidence. For a washed or abraded sample, record the treatment before the subsequent water or vapor test so the sequence can be followed. Recheck evidence after a change to face textile, backing or bonding. When a report does not address the intended assembly question, frame that gap as the next test question instead of treating a different measurement as a proxy.

Discuss this material question